Optical Edge Detection Is Not Working Properly - HEIDENHAIN ND 1300 Operating Instructions Manual

Symptoms, Probable Causes & Solutions

Optical edge detection is not working properly

Probable cause 1:
Possible solution:
Refer to Evaluating optical light levels in Chapter 10: Setup for instructions regarding
1
light levels, and then reorient, repair or replace light sources or optical cables.
Probable cause 2:
Possible solution:
1 Perform a Teach operation or a Distance Cal using the Magnifications Setup screen.
Probable cause 3:
Possible solution:
1 Perform a Cross Cal using the Magnifications Setup screen.
Probable cause 4:
Possible solution:
1 Perform a Parcentric calibration using the Magnifications Setup screen.
Reference or sensor light levels are incorrect
Edge detection is not calibrated:
Edge detector and crosshair probes are not
cross-calibrated:
Multiple system magnifications are not
calibrated to be parcentric:
223