Accessing The Boot Monitor; Interrupting The Bootup Sequence; Using The Run Time Cli - HP P4522A - Traffic Management Server Sa8220 User Manual

C H A P T E R 3
Accessing the
Boot Monitor
You can access the Boot Monitor Command Line Interface in either
of the two ways described in this section.

Interrupting the Bootup Sequence

1. Interrupt the SA8220's bootup sequence by pressing a key at the
following prompt:
Press any key to stop autoboot.
In a few seconds the monitor> prompt displays, confirming
that the Boot Monitor is running:

Using the Run Time CLI

1. Type this command at the prompt:
config sys autoboot disable
2. Then, at the SA8220# prompt, type this command:
HP
reboot
The monitor> prompt displays, confirming that the Boot
Monitor is running.
Using the Boot Monitor CLI
43