HP P4522A - Traffic Management Server Sa8220 User Manual page 168

C H A P T E R 5
Command
config cli prompt
config cli screenlines
config cli telnet-
sessions
config cli ssh-port
NOTE: If you are logged in
using SSH, do not use this
command. Doing so will
change the port parameters
and you will be
disconnected.
config cli timeout
156
HP Traffic Director Server Appliances User Guide
Description
Changes the root level prompt.
config cli prompt <prompt>
where prompt is the new prompt name. The default prompt is an
abbreviation of the product's name, such as "HP SA8220." The
default prompt can be restored by entering "" (two double quotes
with no space between them) as the prompt name.
Specifies the number of lines in the output display.
config cli screenlines <nlines>
where nlines is the number of output lines (8 to 64, the default is
23).
Sets the allowable number of concurrent inbound remote CLI
logon sessions.
config cli telnet-sessions <nsessions>
where nsessions is the number of allowed sessions (1 to 8, and
the default is 3).
Sets the Secure Shell (SSH) port number.
config cli ssh-port <port>
where port is a valid port. Valid ports are port 22 (the default) or
any unused port between 1024 and 65535.
Sets or changes the idle timeout period before automatic logout for
CLI sessions. This feature can be disabled by setting the timeout
value to "0."
config cli timeout <nseconds>
where nseconds is the timeout period in seconds (0, or 30 to
65535). The default is 900 seconds (15 minutes).