HP P4522A - Traffic Management Server Sa8220 User Manual page 173

C H A P T E R 5
Command
config route ospf-dead
config route ospf-
authtype
NOTE: An OSPF Area can
have only one OSPF
authentication scheme.
Select none to specify no
OSPF authentication, or
simple to specify simple
password authentication. If
you select simple , you
must provide an
authentication key: a string
of from one to eight
characters (double quotes
and spaces excluded). The
default is none. Both sides
of the OSPF connection
must use the same
authentication type and key.
Description
Changes the duration of the OSPF router dead interval. The router
dead interval is the number of seconds the SA8220's OSPF
neighbors should wait before assuming that this OSPF SA8220 is
down. This must match the router dead interval of the ingress
router. Valid range is from 1 to 2,147,483,647, and the default is
40.
This value must be at least four times the hello interval.
config route ospf-dead <nseconds>
where nseconds is the number of seconds in the OSPF router
dead interval.
Specifies the OSPF authentication mode. Router Authentication
type and key are security mechanisms to guarantee that routing
information is exchanged only with trusted routers. The type and
key together comprise the "authentication scheme."
config route ospf-authtype [none | simple
ospf-authkey <simplekey> | md5 ospf-authkey
<md5key> keyid <id>
where:
• none disables OSPF Authentication
• simple enables OSPF Authentication (requiring you to
provide an authentication key)
• simplekey is a string of from one to eight characters used as
an authentication password. Spaces and double quotes are not
permitted. This string must match the SA8220's OSPF
neighbors.
• md5key is a string of from one to sixteen characters. Spaces
and double quotes are not permitted.
• id is an integer between 1 and 255.
Routing Commands
161