Updating And Backing Up An Application Using Tftp Through The Cli - 3Com WX3008 AC POE 8GET Installation Manual

Updating an application file
After configuring the Ethernet interface parameters, select 3 from the BootWare main menu to enter the
Ethernet submenu and then select 2. In this example you update the main application file. The following
information appears:
Loading...............................................................................
......................................................................................
.................................Done!
19189956 bytes downloaded!
Updating File flash:/main.bin.........................................................
......................................................................................
......................................................................................
......................................................................................
......................................................................................
......................................................................................
......................................................................................
......................................................................................
.................................................................Done!
Finalizing application update
Select 0 to return to the BootWare main menu, and then press 1 to reboot the system.
If you specify a filename that already exists in the flash memory, the system prompts The file is
exist,will you overwrite it? [Y/N] If you select Y, the existing file will be overwritten.
Make sure that sufficient space is available in the flash memory. In case of insufficient space, the
update cannot proceed and the system will give an error prompt.
The new application file replaces the existing file of the same type, if any, and becomes the only
application file of that type. In this example, main.bin replaces the application file with the attribute
of M and becomes the only main application file.
For details about the file types, refer to Introduction on page 5-1.

Updating and Backing Up an Application Using TFTP Through the CLI

The access control engine and the switching engine have separate file systems. You need to log in to
the CLI of a specific system before you can do file operations in it.
After the device starts, you are directly logged in to the access control engine system. To enter the
switching engine system, use the oap connect slot 0 command; to log out, press Ctrl + K.
5-15