Ping Command - 3Com WX3008 AC POE 8GET Installation Manual

engine of the device as 192.168.0.2, and that of the switching engine as 192.168.0.3 (to configure
the IP address of the switching engine, you need to change to CLI of the switching engine by using
the oap command). Verify the connection by using the ping command.
For operations on the switching engine, you need to log in to the switching engine using the oap
command, configure the IP addresses as mentioned above, and verify the connection by using the

ping command.

2) Maintain the device through the terminal connected to the console port of the device.
<System>ftp 192.168.0.1
Trying 192.168.0.1 ...
Press CTRL+K to abort
Connected to 192.168.0.1.
220 FTP service ready.
User(192.168.0.1:(none)):guest
331 Password required for quest.
Password:
230 User logged in
[ftp]
After a successful connection, you can execute the following commands to maintain the device.
Use the get and put commands to implement file download and backup.
[ftp]get main.bin main.bin
flash:/main.bin has been existing. Overwrite it?[Y/N]:y
227 Entering passive mode (192,168,0,1,6,231).
125 Using exiting data connection..................
226 Closing data connection; File transfer successful.
FTP: 19189956 byte(s) received in 93.156 second(s) 206.00K byte(s)/sec.
[ftp]put main.bin main.bin
227 Entering passive mode (192,168,0,1,6,233).
125 Using exiting data connection
226 Closing data connection; File transfer successful.
FTP: 19189956 byte(s) sent in 21.417 second(s) 896.00Kbyte(s)/sec.
[ftp]quit
221 Service closing control connection
// Enter the username set on the server
// Download the file from the server to the device
// Back up the file from the device to the server
5-19
// Enter the password