Components; Leds - 3Com WX3008 AC POE 8GET Installation Manual

As a power sourcing equipment (PSE), the WX3000 series supports the IEEE 802.3af standard
while being compatible with some PoE powered devices that do not comply with the 802.3af
standard.
The WX3000 series provides power supply through fixed electrical Ethernet ports, with the
maximum power transmission distance of 100 meters (328.08 ft.).
Each Ethernet port of the WX3000 series provides a maximum of 25 W output power to the
attached PoE powered device. In the case of AC input, the maximum output power with full load of
the WX3024 is 370 W, and that of the WX3010 and WX3008 is 125 W; in the case of RPS input, the
maximum output power of the WX3024 is 25 W × 24 = 600 W (Note that the RPS output power
should be at least 700 W).

Components

LEDs

Table 1-6 lists the support of the WX3000 series for LEDs.
Table 1-6 LEDs supported by the WX3000 series
LED
Power status LED (PWR)
PoE/PoE+ status LED (Mode)
RPS status LED (RPS)
Gigabit Ethernet port status
LEDs
Gigabit SFP port status LEDs
Extension slot status LEDs
(MOD1 and MOD2)
Table 1-7 shows the description of the LEDs status
Table 1-7 Description of the LEDs status
LED
Power status
LED
(green/yellow/red
)
WX3024
Supported
Supported
Supported
Supported
Supported
Supported
Mark Status
Solid green
Blinking green (1 Hz)
PWR
Solid red
Solid yellow (1 Hz)
Off
WX3010
Supported
Supported
Not supported
Supported
Supported
Not supported
The system is going through the power on
self test (POST) or downloading software.
The system is working normally.
The system failed to pass the POST or has
detected a serious fault.
At least one port has failed the POST or
detected a minor fault.
No AC input is present.
1-6
WX3008
Supported
Supported
Not supported
Supported
Not supported
Not supported
Description