Table of Contents
Advertisement
3
Installing the Device
When you ask your sales agent to maintain your device, make sure that the dismantlement-preventive
seal of H3C on a mounting screw of the device chassis is intact. If you want to open the chassis, you
should contact the agent for permission. Otherwise, you will bear any consequence resulting from your
actions.
Installing the Device in a 19-inch Rack
The WX3000 series can be installed in a standard 19-inch rack, and the installation falls into the
following four scenarios:
Installing the device with front mounting brackets.
Installing the device with front and rear mounting brackets.
Installing the device with front mounting brackets and a tray.
Installing the device with front mounting brackets and slide rails.
Refer to Table 3-1 for the installation scenarios supported by the device models.
Table 3-1 Installation scenarios supported by the WX3024 and WX3010
Device Model
WX3024
WX3010
WX3008
If the width of the device is more than 300 mm (11.8 in.), the front mounting brackets can be used
only for fixing the device, rather than weight-bearing.
The slide rails provided by H3C are suitable only for H3C standard racks with the depth of 1000 mm
(39.37 in.). You need to seek other supporting means if your rack has a different depth.
Front and rear
Front mounting
brackets
Not supported
Supported
Supported
Not supported
Supported
Not supported
Front mounting
mounting
brackets and a
brackets
Supported
Supported
Supported
3-1
Front mounting
brackets and
tray
slide rails
Supported
Not supported
Not supported
Advertisement
Table of Contents
