Updating Applications Through A Serial Connection - 3Com WX3008 AC POE 8GET Installation Manual

Figure 5-6 Sending the application file using XMODEM
After download completion, the terminal displays the following information:
Download successfully!
19189956 bytes downloaded!
Updating Basic BootWare? [Y/N]Y
Updating Basic BootWare................Done!
Updating Extend BootWare? [Y/N]Y
Updating Extend BootWare..............Done!
Change the baud rate from 115200 bps back to 9600 bps in HyperTerminal and reboot the device.
The file name, size and path shown in the figures are for reference only and may differ from the
actualities on your device. Before updating the software of your device, check the current
BootWare version and application version to make sure that the correct file is used for the update.
After downloading files with a changed baud rate, timely change the baud rate back to 9,600 bps in
HyperTerminal to ensure the normal display on the terminal screen when the system boots or
reboots.

Updating Applications Through a Serial Connection

To update an application file through a serial connection, you need to enter the serial submenu. Select
2 from the BootWare main menu to enter the serial submenu. For details about this submenu, refer to
section Serial submenu on page 5-6.
You can modify the serial interface baud rate to accelerate the file update. For details, refer to section
Modifying Serial Communication Parameters on page 5-8. Select 2 from the serial submenu. The
following information appears:
5-12