Ipv6-Based Vrrp Configuration Examples - H3C LS-3100-52P-OVS-H3 Operation Manual

Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Virtual MAC
Master IP
The above information indicates that in VRRP group 1 Switch A is the master, Switch B is the backup
and hosts with the default gateway of 202.38.160.100/25 accesses the Internet through Switch A; in
VRRP group 2 Switch A is the backup, Switch B is the master and hosts with the default gateway of
202.38.160.200/25 accesses the Internet through Switch B.

IPv6-Based VRRP Configuration Examples

This section provides these configuration examples:
Single VRRP Group Configuration Example
VRRP Interface Tracking Configuration Example
Multiple VRRP Group Configuration Example
Single VRRP Group Configuration Example
Network requirements
Host A needs to access Host B on the Internet, using 1::10/64 as its default gateway.
Switch A and Switch B belong to VRRP group 1 with the virtual IP addresses of 1::10/64 and
FE80::10.
If Switch A operates normally, packets sent from Host A to Host B are forwarded by Switch A; if
Switch A fails, packets sent from Host A to Host B are forwarded by Switch B.
: Vlan-interface2
: 1
: UP
: 100
: YES
: NONE
: 202.38.160.100
: 202.38.160.1
: Vlan-interface3
: 2
: UP
: 110
: YES
: NONE
: 202.38.160.200
: 0000-5e00-0102
: 202.38.160.131
Adver. Timer : 1
State : Backup
Run Pri : 100
Delay Time : 0
Adver. Timer : 1
State : Master
Run Pri : 110
Delay Time : 0
1-25