Configuration - HP Ew2400 - JetDirect Print Server Administrator's Manual

Configuration Page Messages
HP Jetdirect Configuration/General Information
Information in this section provides general HP Jetdirect print
server configuration as described in
see Table 9.11.
Table 9.1 HP Jetdirect Configuration (1 of 2)
Message
STATUS:
MODEL NUMBER:
HARDWARE
ADDRESS:
FIRMWARE VERSION:
NETWORK
CONNECTION TYPE
DATA RATE
DETECTED
LINK CONFIG
ENWW
Description
Current state of the HP Jetdirect print server.
I/O CARD READY, or READY: The HP Jetdirect print server
has successfully connected to the network and is awaiting
data.
I/O CARD INITIALIZING, or INITIALIZING: The
HP Jetdirect print server is initializing the network protocols.
For more information, see the status line for each protocol
on the configuration page.
I/O CARD NOT READY, or ERROR: There is a problem with
the print server or its configuration.
An error code and message is displayed if the print server
is not ready. For more information, see
The model number of the HP Jetdirect print server (for
example, J7951A)
The 12-digit hexadecimal network hardware (MAC) address
of the HP Jetdirect print server installed in the printer or
device. This address is assigned by the manufacturer.
The firmware revision number of the HP Jetdirect print
server currently installed in the printer.
(ew2400) Specifies the type of network connection:
Wireless or Wired.
(ew2400) Specifies the network data rate depending on the
type of network connection:
1 - 54 Mbps (Wireless 802.11g)
10 Mbs, 100 Mbps (Wired 10/100Base-TX)
(ew2400) Specifies the active link communication mode:
802.11: Wireless 802.11g
10T HALF: 10 Mbps, half-duplex (wired port)
10T FULL: 10 Mbps, full-duplex (wired port)
100TX HALF: 100Mbps, half-duplex (wired port)
100TX FULL: 100Mbps, full-duplex (wired port)
HP Jetdirect Configuration Page 205
Table 9.1. For error messages,
Table 9.11.