Switch Configuration - HP 635n - JetDirect IPv6/IPsec Print Server How To Use Manual

Select "X.509
Certificates"
and "Add..."
Now using the
certificate that
the CA issued
to Jetdirect –
"finance.cer"
was the file,
you can map it
here. Click
"OK".

Switch Configuration

Where are we?
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Each Switch (Authenticator) configuration will vary. For this example, we are using an HP J4902A
6108 ProCurve Switch. Essentially, we enable 802.1X for port 8 of the switch and tell the switch
where the Radius server is. We haven't installed the Radius server, but we will soon. The switch will
relay the EAP messages from Jetdirect to the Radius Server. The Radius server will work with Active
Directory to determine if the user can be authenticated. If so, the switch will open up the port and
allow Jetdirect access to the network.
Based upon this configuration, the Jetdirect device needs to be installed in Port 8. That is the only
port that is enabled for 802.1X. Refer to Figure 16 for an example configuration file.
Installing Internet Authentication Service
Installing a Certificate Authority
Creating a Certificate Template
Issuing a Certificate
Creating a User for HP Jetdirect
Switch Configuration
HP Jetdirect Certificate Configuration
IAS Configuration
HP Jetdirect 802.1X Configuration
40