Pioneer CLD-V5000 Programmer's Reference Manual page 58

Chapter Three • CLD-V5000 Level III
47) REGISTER C SET
Function: Changes the current setting of Register C. (Miscellaneous)
Format: Integer
Explanation: When power is turned ON, and SW 4 is set ON/DOWN, the Side
Repeat function of Register C is set to ON. If Function Switch 5 on
the rear panel of the player is ON (DOWN), the Load Start and
Power-On Start functions of Register C are also set to ON. If
Function Switch 6 is ON (DOWN), background color will be set to
Black. Baud Rates of 9600 and 2400 cannot be set with this
command. Note that some functions, such as Test Mode, may
suspend playback or disable further control. Test Mode is for use
only by Authorized Service Centers, for evaluating player operations.
The functions listed below can be set. To set a function to ON,
give the value indicated by the integer. To set multiple functions
to ON, the integer values must be added up. All eight functions can
be specified in combination by using the decimal values from 0 to
255. The completion status is returned immediately.
NOTE: When "All Repeat", "Side Repeat", "Chapter Repeat" or
"Track Repeat" is selected by the RCU, the "Side Repeat" function of
Register C goes to "ON" and when "Auto Return" is selected by the
RCU, the "Side Repeat" function of Register C goes to "OFF".
Figure 3-U
Execution: * Initial value 0
3 R C <C/R>
* Side-Repeat, Load-Start to ON, background color BLUE
1 6 R C <C/R>
* Background Color BLACK; Side-Repeat and Load-Start to OFF
3-42
LD/CD
R C
Integer Function
1 Repeat
2 Load-Start
4 Power-on-Start
8 (Not Used)
16 Background Color
32 TxD Terminator
64 BAUD Rate
128 Test Mode
TP 121 v. 1.0 • 1/96
R <C/R>
R <C/R>
CLD-V5000 Level III User's Manual
1 0
ON OFF
ON OFF
ON OFF
— —
BLACK BLUE
<CR+LF> <CR>
1200 4800
ON OFF