Pioneer CLD-1720K Operating Instructions Manual

CD CDV LD PLAYER
CLD-1720K. tas
CD-V740 =
The function of both units, CLD-1720K and CLD-V740
are identical.
Operating
fl acarttiecer
Re Qaerk BP ae,
Instructions
I acarleawrnala
Re@iul tre ELEN CE WRe
diet LY
DIGITAL AUDIO LASER DISC
@ This player does not apply to business use, and CD-
ROM/CD graphic discs cannot be played with this player.
Thank you for buying this Pioneer product
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same.
WARNING: To PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE.
IMPORTANT NOTICE
{For U.S. and Canadian models]
The serial number for this equipment is located on the rear panel.
Please write this serial number on your enclosed warranty card
and keep it ina secure area. This ts for your security
[For Canadian model]
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
BLADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE,
ATTENTION: Pour PREVENIR LES CHOCS
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR, UNE PRISE DE COURANT
OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES
LAMES PEUVENT ETRE INSEREES A FOND SANS EN
LAISSER AUCUNE PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch.
U.S., Canadian, European, U.K., and Australian models
are not provided with this switch.
The line voltage selector switch is located on the rear panel
of this player. Before your player is shipped from the factory,
the switch is set to the power requirements of the player's
destination. Check that it is set properly before plugging
the power cord into the outlet. {f the voltage is not properly
set or if you move to an area where the voltage requirements
differ, adjust the selector switch as follows:
Use a medium-sized (flat blade) screwdriver. Insert the tip
of the screwdriver into the groove of the selector switch
and turn it to set the player to the power voltage of your
area
Set the selector so that
arrow points to power
voltage of your area
{Figure shows arrow
pointing to 220 volts.)
CAUTION: Be sure to use the shielded cables when
connecting this equipment to other devices.
@ PIONEER'
The Ast of Entertainment