Initial Settings - Pioneer CLD-V5000 Programmer's Reference Manual

Chapter Three ¥ CLD-V5000 Level III

3.3 Initial Settings

The internal registers and switches are set to the following conditions when power
is turned on. The settings are not re-initialized when the player is put into Park or
Door Open Mode. Do not forget to set them to the parameters needed when creating
an application program. Some of the switch settings can be set only via Register
Commands under computer control; others can be set by using the DIP Switches
on the rear panel of the player or via Registers. For more information see Section
3.7.6 Register Control Commands, page 3-39, and Section 2.3 Function
Switch Settings, page 2-6.
Register/Switch
Key lock
Video switch
Audio switch
Display switch
Address flag
Speed parameter
Communication
Control
REG. A
REG. B
REG. C
REG. E
Figure 3-D
3-4
Initial Setting
0
1
7
0
3
60
Mode 3
3
0
1
Depends on
Function Switch
CLD-V5000 Level III UserÕs Manual
TP 121 v. 1.0 ¥ 1/96
Status
Unlocked
ON
Digital Stereo
(If digital audio is
encoded on the disc.)
OFF
Frame - CAV; Time - CLV
Track - CD, CDV
Normal (X1) speed
Automatic Status
Frame/Chapter - LD;
Track/Time - CD, CDV
Normal squelch
Side Repeat ON and Blue
Squelch.
(BAUD Rate can be set
using SW 1 & 2, Auto Start
can be set using SW 5, and
Squelch color of Blue or
Black can be selected with
SW 6 on the back of the
CLD-V5000. Some options
can also be set through
Register C under
Level III control.)