Pioneer CLD-V5000 Programmer's Reference Manual page 35

NOTE: This last example will display 26:20 on the front panel and on-screen
display, but if a ?F <CR> is sent to the player via computer, the player will return
26:20:12, the minutes, seconds, & frame number.
NOTE: Users should note that searching to the index and block levels on a CD is
possible with Level III computer control. These searches are not possible with the
remote control unit.
Execution/CDs: * CD in Play or Pause Mode TM sets address flag to Time
T M 1212 S E <CR>
* Searches to 12 minutes, 12 seconds and enters Pause Mode
BK 030303 S E <CR>
* Searches to 03 minutes, 03 seconds, Block 03, enters Pause Mode
NOTE: The command ?B returns 030303. On a CD, track and elapsed time or
track-index and time within the track can be displayed by using the remote control
unit. Determining the current block number, however, must be done from Level III
control using the ?B command. For details see Section 3.7.4, Request Commands:
#36, Block No. Request on page 3-33.
T R 03 S E <CR>
* Searches to track 03 and enters Pause Mode.
IX 03 01 S E <CR>
* Searches to Track 03, Index 01 and enters Pause Mode.
NOTE: If only one index is encoded on a CD track, and an instruction is sent to the
player to search to index 3 of that track, (IX0303SE) the player will search to the
beginning of the next track. In this case, it will search to the beginning of Track 4.)
The range of address entries possible on CDs are described on page 3-7 and again in
the reference chart below.
Address Flag
Figure 3-I
CLD-V5000 Level III UserÕs Manual
CLD-V5000 Level III ¥ Chapter Three
Range of Address
Time: Minutes 00-99, Seconds 00-59*
Block: Minutes 00-99, Seconds 00-59, Blocks 00-74
Tracks: 01-99
Index Track 01-99 Index 00-99
* 74 minutes is the maximum playing time on a CD.
R <CR>
BK sets address flag to Block
R <CR>
TR sets address flag to Track
R <CR>
IX sets address flag to Index
R <CR>
TP 121 v. 1.0 ¥ 1/96
3-19