Cosmo COS-GRC366KB Installation Instructions Manual page 63

CONVERT OVEN BURNERS
This product cannot be converted to Natural gas (NG) or Propane gas (LP) by
adjusting or tightening the oven orifices. The orifices must be replaced.
To gain better access to the oven components, the oven door may be
detached from the range. See "Removing/Assembling Oven Door" section.
Tool Needed
• 3/8" (9.5 mm) combination wrench
Converting Broil Burner
1. Empty the oven.
2. Remove the 4 screws from broil
burner baffle at the oven top.
3. Remove the 3 screws from broil
burner while supporting it.
4. Carefully remove broil burner
assembly (burner, igniter, and
baffle) from broil orifice holder.
5. Tip front of assembly downwards
and lean assembly out of the
way, being careful not to
damage igniter wire or oven
surfaces.
6. Using a 3/8" (9.5 mm)
combination wrench, replace the
broil orifice with the correct fuel
type orifice. Gas orifices are
stamped with a size number.
Refer to the orifice chart earlier
for correct NG and LP gas orifice
sizes.
Screws
Baffle
Igniter
Burner
Orifice
Screws
Orifice holder
63