Cosmo COS-GRC366KB Installation Instructions Manual page 27

UNPACK RANGE
• Use two or more people to move and install range. Failure to do so can
result in back or other injury.
1. Remove all tape and packaging materials. Check for film on stainless
steel parts, padding/spacers on and around door and face of oven,
cardboard and plastic on and around racks, etc. Failure to remove
packaging materials could result in damage to the appliance. Do not
dispose of anything until the installation is complete.
NOTE:
• Do not remove any warning-type labels, the model and serial
number label, or the Tech Sheet that is located on the back of the
range.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or
abrasive cleaners to remove tape or glue. These products can
damage the surface of your range.
• Do not push or pull the range by grabbing the open oven door or
cooktop only. Doing so can result in serious damage to the range.
• Do not lift the range using the cooktop or oven door handle. Doing
so can cause damage and improper operation of the range.
• To reduce the weight of the range while being moved, adjusted,
and installed, leave the cooktop grates, oven racks, and any other
accessories to the side until they are ready to be installed later in
these instructions.
• To further reduce the weight of the range while being moved,
adjusted, and installed, detach the oven door from the range. See
"Removing/Assembling Oven Door" section.
WARNING
EXCESSIVE WEIGHT HAZARD
27