Audiomode - Cisco ATA186-I2 Administrator's Manual

Audio Configuration Parameters

AudioMode

Description
This parameter represents the audio operating mode. The lower 16 bits are for the Phone 1 port, and the
upper 16 bits are for the Phone 2 port.
Value Type
Bitmap
Default
0x00150015
Voice Configuration Menu Access Code
312
Related Parameters
•
•
•
Table 5-1 AudioMode Parameter Bit Definitions
Bit Number
0 and 16
1 and 17
2 and 18
3 and 19
4-5 and 20-21
6-7 and 22-23
8-15 and 23-31
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
5-24
LBRCodec, page 5-23
ConnectMode, page 5-32
RxCodec, page 5-22
Definition
0/1—Disable/enable silence suppression for all audio codecs. Silence suppression is enabled by
default.
0—Enable selected low-bit-rate codec in addition to G.711. This setting is the default.
1—Enable G.711 only.
0/1—Disable/enable fax CED tone detection. This feature is enabled by default.
Reserved.
DTMF Transmission Method:
0—Always in-band.
•
1—By negotiation.
•
2—Always out-of-band.
•
• 3—Reserved.
Hookflash Transmission Method:
0—Disable sending OOB hookflash message.
•
1—By negotiation (H.245 message).
•
2—Always out-of-band (H.245 message).
•
3—Use Q931message to send user keypad information for DTMF or hookflash transmission.
•
Reserved.
Table 5-1 on page 5-24 provides definitions for each bit.
Chapter 5 Parameters and Defaults
OL-4804-01