Establishing Authentication With Cisco H.323 Gatekeeper - Cisco ATA186-I2 Administrator's Manual

Chapter 4 Basic and Additional H.323 Services

Establishing Authentication with Cisco H.323 Gatekeeper

You can configure the Cisco ATA to establish authentication with a Cisco H.323 Gatekeeper. The
Cisco ATA supports two authentication methods:
•
•
To configure either authentication method, use the following procedure:
Procedure
Set the UseLoginID parameter to 1. This setting indicates that the LoginID0 and LoginID1 fields will
Step 1
be used for Cisco ATA H.323 registration.
Set the UID0 and UID1 parameters to the E.164 phone numbers that are assigned to the FXS ports on
Step 2
the Cisco ATA.
Set the LoginID0 and LoginID1 parameters to the H.323 ID. The H.323 ID is used when the Cisco ATA
Step 3
registers with the H.323 gatekeeper. This ID is also used as the account ID for the RADIUS server.
Set the PWD0 and PWD1 parameters to the passwords for the Phone 1 and Phone 2 FXS ports (the
Step 4
passwords in the RADIUS server), respectively.
Set the NTPIP and AltNTPIP parameters to the IP addresses of the NTP servers in your network.
Step 5
Select the authentication method using the AutMethod parameter (0 indicates no authentication; 1
Step 6
indicates the Cisco registration level security method; 2 indicates the Cisco admission level security
method).
Note
Related Configuration Parameters
•
•
•
•
•
•
•
•
•
•
OL-4804-01
Cisco registration level-security
Cisco admission-level security (per-call basis)
The authentication methods are Cisco Proprietary H.235 implementations, which use the Cisco
access/clear token structure rather than the VocalTec crypto token structure.
UseLoginID, page 5-19
AutMethod, page 5-20
LoginID0, page 5-18
LoginID1, page 5-19
UID0, page 5-16
UID1, page 5-17
PWD0, page 5-16
PWD1, page 5-18
NTPIP, page 5-10
AltNTPIP, page 5-11
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
Important Basic H.323 Services
4-5