Table of Contents
Advertisement
Chapter 9
Troubleshooting
•
Priority=62, which means that the facility value is 7 (network new subsystem) and the severity value
is 6 ( informational messages). You can derive this information from RFC-3164.
•
The time offset of the first message is 00:04:00, which means that the most recent Cisco ATA reset
was four minutes earlier.
•
The tag value is 01, which corresponds to DHCP messages. This is derived from
page
The messages include the DHCP server IP, lease time, subnet mask and router.
•
Example—TFTP messages
<94>00:04:35 192.168.3.237 [02]:Rx TFTP file:ata00012d010828(684) ok
<94>00:00:02 192.168.3.237 [02]:Rx TFTP file:ata00012d010828(-10) fail
These messages include the following information:
Priority=94, which means that the facility value is 11 (FTP daemon) and the severity value is 6 (
•
informational messages). You can derive this information from RFC-3164.
The time offset of the first message is 00:04:35, which means that the most recent Cisco ATA reset
•
was four minutes and 35 seconds earlier.
The tag value is 02, which corresponds to TFTP messages. This is derived from
•
page
The messages include TFTP filename, file size and transmission result.
•
Example—Cisco ATA Configuration Update Message
<30>00:00:01 192.168.3.237 [03]:ATA Config Update OK
This message includes the following information:
Priority=30, which means that the facility value is 3 (system daemon) and the severity value is 6 (
•
informational messages). You can derive this information from RFC-3164.
The time offset of the message is 00:00:01, which means that the most recent Cisco ATA reset was
•
one second earlier.
The tag value is 03, which corresponds to Cisco ATA configuration-update messages. This is
•
derived from
This message shows indicates the status of the Cisco ATA configuration-file update.
•
Example—System Reboot Message
<31>00:00:00 192.168.3.220 [04]:Reboot from ata00012d010829(HWVersion1)
@192.168.3.220 (warmStart:0)
This message includes the following information:
Priority=31, which means that the facility value is 3 (system daemon) and the severity value is 7
•
(debug-level messages). You can derive this information from RFC-3164.
•
The time offset of the message is 0.
The tag value is 04, which corresponds to system-reboot messages. This is derived from
•
on page
•
This message includes the MAC address, hardware version and IP address of the Cisco ATA, and
the reason for the reboot.
OL-4804-01
5-62.
5-62.
Table 5-9 on page
5-62.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
5-62.
Using System Diagnostics
Table 5-9 on
Table 5-9 on
Table 5-9
9-7
Advertisement
Table of Contents
