Table of Contents
Advertisement
Chapter 3
Configuring the Cisco ATA for H.323
You can access the web configuration page from any graphics-capable browser, such as
Microsoft Internet Explorer or Netscape. This provides easy initial access to the Cisco ATA
configuration within the administrator's private network.
Follow these steps to set parameters using the web configuration page:
Procedure
Make sure that your PC and the Cisco ATA are already networked and visible to each another.
Step 1
Step 2
Open your web browser.
Step 3
Enter the URL for your configuration page. The default URL for the web server is:
http://IP Address/dev
For example, the configuration page for a Cisco ATA with the IP address 192.168.3.225 is:
http://192.168.3.225/dev
Select the values for the items that you want to configure. See
Step 4
a complete list of parameters and their definitions. Also see
listing of configurable features and references to their corresponding parameters.
Note
Cisco strongly recommends that you set a password. Use the UIPassword parameter to configure a
password, after which you are prompted for the password whenever you attempt to change a parameter
value. Configuration parameters cannot be accessed through the voice configuration menu if the
password contains one or more letters and can be changed only by using the web interface or the TFTP
configuration method.
Click apply to save your changes.
Step 5
The Cisco ATA automatically refreshes its configuration.
Close your web browser.
Step 6
Refreshing or Resetting the Cisco ATA
Whenever you make configuration changes to your Cisco ATA configuration file, you can refresh or
reset the Cisco ATA for these configuration changes to immediately take effect. If you do not refresh or
reset the Cisco ATA, the configuration changes will take effect the next time the Cisco ATA contacts
the TFTP server, which occurs based on the configured value of the CfgInterval parameter.
A refresh procedure will update the Cisco ATA configuration file. A reset procedure will also update the
Note
Cisco ATA configuration file, and will additionally power-down and power-up the Cisco ATA. A reset
should not be necessary if your only goal is to update the configuration file.
OL-4804-01
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
Refreshing or Resetting the Cisco ATA
Chapter 5, "Parameters and Defaults,"
Table 4-4 on page 4-12
for an alphabetical
for
3-25
Advertisement
Table of Contents
