Table of Contents
Advertisement
Configuring the Cisco ATA for H.323
This section describes how to configure the Cisco ATA to operate with the H.323 signaling image and
how the Cisco ATA obtains the latest signaling image.
You can configure the Cisco ATA for use with H.323 with any of the following methods:
By using a TFTP server—This is the Cisco-recommended method for deploying a large number of
•
Cisco ATAs. This method allows you to set up a unique Cisco ATA configuration file or a
configuration file that is common to all Cisco ATAs. The Cisco ATA can automatically download
its latest configuration file from the TFTP server when the Cisco ATA powers up, is refreshed or
reset, or when the specified TFTP query interval expires.
By using manual configuration:
•
–
–
This section contains the following topics:
Default Boot Load Behavior, page
•
follows by default when it boots up. It is very important to understand this process because, if your
network environment is not set up to follow this default behavior, you need to make the applicable
configuration changes. For example, by default, the Cisco ATA attempts to contact a DHCP server
for the necessary IP addresses to achieve network connectivity. However, if your network does not
use a DHCP server, you must manually configure various IP settings as described in this section.
•
Specifying a Preconfigured VLAN ID or Disabling VLAN IP Encapsulation, page
includes a table of the parameters you can configure for VLAN and CDP settings.
•
Steps Needed to Configure the Cisco ATA, page
the general configuration steps you must follow to configure the Cisco ATA.
•
Configuring the Cisco ATA Using a TFTP Server, page
configuring the Cisco ATA by using a TFTP server, which is the recommended configuration
method for the deployment of a large number of Cisco ATAs.
•
Voice Configuration Menu, page
network connectivity for the Cisco ATA and how to perform a factory reset if necessary.
OL-4804-01
Voice configuration menu—This is the method you must use if the process of establishing IP
connectivity for the Cisco ATA requires changing the default network configuration settings. These
settings are CDP, VLAN, and DHCP. You also can use the voice configuration menu to review all
IP connectivity settings. The voice configuration menu can also be used when Web access is not
available.
Web-based configuration—This method is convenient if you plan to deploy a small number of
Cisco ATAs in your network. To use this method, the Cisco ATA must first obtain IP connectivity,
either through the use of a DHCP server or by using the voice configuration menu to statically
configure IP addresses.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
C H A P T E R
3-2—This section describes the process that the Cisco ATA
3-5—This section provides tables that summarize
3-8—This section describes procedures for
3-20—This section includes information on how to obtain basic
3
3-3—This section
3-1
Advertisement
Table of Contents
