Table of Contents
Advertisement
Chapter 6
Call Commands
Call Command Behavior
Table 6-4
commands.
U.S. Call Command Default
Af;AH;BS;NA;CS;NA;Df;EB;Ff;EP;Kf;EFh;HH;Jf;AFh;HQ;I*67;gA*82;fA#90v#;OI;H#72v#;bA#74
v#;cA#75v#;dA#73;eA*67;gA*82;fA*70;iA*69;DA*99;xA;Uh;GQ;
Sweden Call Command Default
BS;NA;CS;NA;Df;EB;Ff0;ARf1;HPf2;EPf3;AP;Kf1;HFf2;EFf3;AFf4;HQh;HH;Jf1;HFf2;EFf3;AFf4;
HQ;Af4;HQ;I*31#;gA#31#;gA*90*v#;OI;H*21*v#;bA*61*v#;dA*67*v#;cA#21#;eA#61#;eA#67#;e
A*31#;gA#31#;gA*43#;hA#43#;iA*69#;DA*99#;xA;Uh;GQ;
Table Notations
The following notations are used in
•
•
•
•
•
•
•
•
•
Note
The notations in
syntax examples shown earlier in this section. The Summary of Commands column in
on the actual command syntax used in the default Call Command strings for the United States and
Sweden.
Table 6-4
Call Command Behavior
Cisco ATA State and its Definition
IDLE: Phone is on-hook; Cisco ATA is
waiting for incoming call
PREDIAL: Phone just went off-hook but
no DTMF has been entered yet;
Cisco ATA plays dial-tone
OL-4804-01
summarizes differing Call Command behavior based on the U.S. and Sweden default call
FE—Far end
AFE—Active Far End, which is a connected far end that is not placed on hold
WFE—Waiting Far End, which is a connected far end being placed on hold, or an incoming caller
waiting to be answered
R—Hook Flash
ONH—On Hook
OFH—Off Hook
0-9,*,#—DTMF digits
v—a variable length string, usually a phone number, and does not include #
CWT—call-waiting tone
Table 6-4
include abbreviations for input sequence behavior. Refer to the tables and
Summary of Commands (Input Sequence and Actions)
•
OFH—Start dial tone and go to PREDIAL state.
New incoming call or a waiting call (started before it enters IDLE)—Start
•
ringing the phone and go to the RINGING state.
United States and Sweden:
# , *—Stop dial-tone, go to the CONFIG state, and prepare to accept a
•
complete configuration sequence.
0-9: Stop dial tone, start invoking dial-plan rules, and go to the DIALING
•
state to accept a complete phone number.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
Table
6-4:
Call Command Behavior
Table 6-4
is based
6-7
Advertisement
Table of Contents
