Table of Contents
Advertisement
Troubleshooting
This section describes troubleshooting procedures for the Cisco ATA:
•
•
•
•
•
•
•
•
•
•
•
•
The term Cisco ATA is used throughout this manual to refer to both the Cisco ATA 186 and the
Note
Cisco ATA 188, unless differences between the Cisco ATA 186 and Cisco ATA 188 are explicitly
stated.
General Troubleshooting Tips
The suggestions in this section are general troubleshooting tips.
•
•
•
OL-4804-01
General Troubleshooting Tips, page 9-1
Symptoms and Actions, page 9-2
Installation and Upgrade Issues, page 9-3
Debugging, page 9-4
Using System Diagnostics, page 9-5
Local Tone Playout Reporting, page 9-9
Obtaining Network Status Prior to Getting IP Connectivity, page 9-10
Obtaining Network Status After Getting IP Connectivity, page 9-11
DHCP Status HTML Page, page 9-12
Real-Time Transport Protocol (RTP) Statistics Reporting, page 9-12
Frequently Asked Questions, page 9-13
Contacting TAC, page 9-15
Make sure that the DHCP server is operating correctly. Note that the function button blinks slowly
when the Cisco ATA attempts to acquire the DHCP configuration.
If the green activity LED is not flashing after you connect the Ethernet cable, make sure that both
the power cord and the Ethernet connection are secure.
If there is no dial tone, make sure that the telephone line cord from the telephone is plugged into the
appropriate port on the Cisco ATA. Make sure that your Cisco ATA is properly registered on your
Call Control system. Test another phone; if this phone does not work either, there may be a problem
with the current configuration or with the Cisco ATA.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for H.323 (version 3.0)
C H A P T E R
9
9-1
Advertisement
Table of Contents
