Subscribe to Our Youtube Channel
Related Manuals for Glow Bricks Lego 80113
Summary of Contents for Glow Bricks Lego 80113
- Page 2 First of all separate the building by each floor...
- Page 3 Get the 2 floor and lighting part B Assemble the 4pcs of lighting plates at the bottom and the position has to be exactly same as below...
- Page 4 Remove the shown parts out from the 1 floor Put the 2 floor back on the 1 floor, before close down leave the white lighting plates outside, must leave the connector (red circle) inside the house...
- Page 5 The white lighting plates, gold clips and the connector with long wire attached would be left outside as shown Assemble the 1x4 lighting plate and restore the cover after...
- Page 6 The connector would be moved to the back side of the house Then assemble the 1x3 lighting plate...
- Page 7 Replace the gold clips on the wire by the lighting gold clips then put the red lanterns back on them...
- Page 8 Now take lighting part A, assemble the shown lighting plates onto the ceiling of 1st floor as shown and connect the connector mentioned on page 4 (red circle) Then move the remain lighting parts to the 2 floor by the stairway...
- Page 9 Lift up the ceiling shown in red circle, put the grey lighting plate into the washroom then assemble it on the ceiling Then assemble the 1x3 lighting plate...
- Page 10 Put the roof back and assemble the 1x10 lighting plates on it Move the gold lighting clips and replace them...
- Page 11 The led bulb at the end would be placed inside the red round head Then assemble the 1x3 lighting plate Place the lanterns back to the lighting gold clips then this part is done...
- Page 12 Replace the yellow round plate on the cart by the lighting part C Connect both of the connectors to the USB cable then you can light it up...
Need help?
Do you have a question about the Lego 80113 and is the answer not in the manual?
Questions and answers