Subscribe to Our Youtube Channel
Related Manuals for Glow Bricks Lego CHEVROLET CORVETTE
Summary of Contents for Glow Bricks Lego CHEVROLET CORVETTE
- Page 2 Start assembling the rear light, remove the shown parts first...
- Page 3 Replace the clear red parts on the brake lights by the lighting parts Place the wires in between the lights properly make sure they’re not placed on the studs then restore the parts...
- Page 4 Turn to the front side, remove the shown parts to assemble the lights at the front Turn the car upside down then place the wires at the bottom...
- Page 5 Get the lights on one side through the hole beside the tires to get it on the surface...
- Page 6 Place the wire connecting the light bulbs in between the studs Adjust the length, don’t make it too many wires disposed then restore the parts to stable it...
- Page 7 Put the inner side of the light cover, if there’s too much wire the cover won’t be attached tight, you need to lift up the part on last step and adjust the length. If it looks ok like the picture below you can put the other cover back on Now do the same thing for the other side...
- Page 8 The steps are basically same as the previous one Restore the engine cover, and you should not see any cable disposed then this part is done...
- Page 9 Remove the black plate at the bottom, place the wire in between the studs to stable it then put the plate back...
- Page 10 Assemble the red lighting plate as shown then put the top back on the car Remove the shown part on the side, place the wire in between the studs then put the part back on...
- Page 11 Put the removed parts back to the top Now gather three connectors at the rear side at the bottom There’s a hole at the corner of the trunk to move the connector of the rear light out...
- Page 12 Connect the plugs then you may light it up convertible, you may place the lighting plate at If you want to make the car the bottom or you can take it away of course...
- Page 13 If you want to power up by battery, you need to place the battery case inside the trunk, remove the right rear bumper then place the connectors from the case through the hole Then connect with the plugs from the lights...
- Page 14 After the plugs connected, place the battery case inside the trunk Its pretty tight but I’m sure the case could be placed inside the trunk...
- Page 15 Remove the shown parts if you want to put the hard cover with light on Place the wire in between the red tile and the grey plate...
- Page 16 Place the hard cover on the car, connect the cable to the battery case...
- Page 17 Restore the cover and it’s done...
Need help?
Do you have a question about the Lego CHEVROLET CORVETTE and is the answer not in the manual?
Questions and answers