Page 2
Take lighting part A, find the 1x4 lighting plate with two connectors attached, assemble the lighting plate as shown and the connectors should be facing the side of the garden...
Page 3
Assemble the other lighting plate to the other side (red circle) Assemble the remain lighting plate on the end shown in red circle...
Page 4
The two seperated green lighting round plates attached to the lighting plate in previous step would be assembled on the green parts on top The remain lighting round plates would be moved to outside, take away the shown white parts to move the lighting round plates outside then restore the white parts...
Page 5
Assemble the green lighting round plates (red circle) then remove the shown parts on the pink flowers and assemble the pink lighting round plates on the flowers Restore the parts on top of the lighting parts after that...
Page 6
Remove the top and the windows away to get the led bulbs to the fountain Remove the top of the fountain and place the first bulb at the bottom...
Page 7
Then place the other bulb above right in between the clear blue and white part...
Page 8
Take lighting part B to assemble them on the trees Start from the shorter tree, assemble first three pcs of lighting round plates from the connector even on the tree...
Page 9
Place the tree back on the model and place the wire with connector under the tiles Place the other tree and assemble the remain lighting round plates on it...
Page 10
Assemble lighting part C on the other tree, just place the round plates on the tree evenly and hide the wires deep inside the branches to made them invisible The 1x6 lighting plate would be assembled inside the house...
Page 11
At last connect the plugs from the trees to lighting part A then you may light up the model by the USB cable Restore the windows afterward and assemble the lighting plate...
Need help?
Do you have a question about the Lego 41757 and is the answer not in the manual?
Questions and answers