Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Glow Bricks Lego Star Wars X-Wing Starfighter
Summary of Contents for Glow Bricks Lego Star Wars X-Wing Starfighter
- Page 1 X-Wing Starfighter...
- Page 2 Take the shown lighting part to assemble it on the front part of the model...
- Page 3 Detach the side and the head as shown Assemble the black lighting plate at the end to the side of the pilot seat...
- Page 4 Assemble the other lighting plate on the detached side then put it back to the plane, leave the other lighting parts outside the cockpit...
- Page 5 The two pieces of white lighting plates will be assembled at the bottom Assemble the clear lighting round plates the each side on the head...
- Page 6 Put the head back and hide the excess wire inside the gap of the joint (inside the blue circle) Take the shown lighting part to assemble it on the rear side Remove the white 2x2 round plates in the blue circle, leave the clear pink dishes...
- Page 7 Combine the pink dishes with the lighting parts Assemble the lighting plate at the bottom then connect the plugs with the lighting parts at front...
- Page 8 After that you may take the grey panel off to hide the connected plugs inside Split the remain lighting parts with one short one long on each side...
- Page 9 Assemble the lighting parts with shorter cable on the lower nozzles which are closer to the lighting plate Move the other lighting parts to the upper nozzle, hide the wire under the plates in the red circle...
- Page 10 Then assemble it on the nozzle, try to make the wire be hidden as many as possible Repeat the same procedure for the other side then this part is finished...
- Page 11 Take the shown parts to assemble them on the wings Get the lighting plate with tile attached to assemble it at the bottom of the wing (Remember the plane is still turned upside down that’s why it’s bottom)
- Page 12 Assemble the lighting plate and the lighting round plate shown in red circles If you take the lighting part with a connector attached by a very long cable, leave it on the side, they would be used to connect the USB cable at the end...
- Page 13 Remove the shown part, except the led strip move the remain lighting parts through it and place the wire in between the studs. Then restore the part and stick the led strips inside the grey circle...
- Page 14 Connect the plugs with the lighting plate at the bottom Now assemble the lighting parts on the other side, basically it’s same way as before...
- Page 15 Then assemble the remain 1x4 lighting plates on the front panel...
- Page 16 After connecting the plugs, you may turn the plane around to assemble the remain lights Open the wing and assemble the lighting plate at the red circle place...
- Page 17 Then assemble the lighting round plate And stick the led strip...
- Page 18 To make it looks better, hide the excess wires and the connectors inside the body Restore the plate and this side is done...
- Page 19 Now repeat the same procedure on the other side If you want to power by battery, connect the small battery case with the lights of the head side and stick it inside the head...
- Page 20 At last, replace the lightsaber by the lighting saber, connect both connectors to the USB...
Need help?
Do you have a question about the Lego Star Wars X-Wing Starfighter and is the answer not in the manual?
Questions and answers