Page 1
For safety, please read this user manual carefully before initial use. Event Lighting reserves the right to revise the manual at any time. Information and specifications within this manual are subject to change without notice. Event Lighting assumes no liability or responsibility for any errors or omissions.
Safety Instructions WARNING Do not connect this product directly to 240V AC mains power. Use only a 24V DC constant voltage power supply. CAUTION Avoid installation near strong magnetic fields or high-voltage cables. Do not operate if the housing, cables, or connections are damaged. ...
Page 3
1. Cutting the Mounting Hole Mark a circle on the ceiling where the Downlight will be installed according to the above table: Ø95mm for DOWN20RGB Ø120mm for DOWN30RGB Precisely cut the hole using the marked guidelines. 2. Connecting Cables ...
Page 4
3. Mounting the Downlight Bend back the two spring clips on the Downlight. Gently push the unit into the hole, allowing the clips to lock onto the ceiling. Ensure a snug fit—the springs should hold the light firmly in place. www.event-lighting.com.au...
Need help?
Do you have a question about the DOWN20RGB and is the answer not in the manual?
Questions and answers