Table of Contents
Advertisement
Quick Links
"PRO SERIES"
Models - Natural Gas
FPB-34DPSTPSI-N-SAN
FPB-26DPSTPSI-N-SAN
Round Flat Pan Thermocouple Piloted
Installation and Operating Instructions
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS
DO NOT ATTEMPT TO INSTALL OR OPERATE THIS APPLIANCE
This fire pit requires a minimum 18-square inches (per side) of cross ventilation.
Failure to provide proper ventilation can void the warranty.
Warning: For Outdoor Use Only
MODELS
Models Propane Gas
FPB-34DPSTPSI-P-SAN 34" Round Burner with 18" Snowflake Burner
FPB-26DPSTPSI-P-SAN 26" Round Burner with 11" Snowflake Burner
Safety Ignition (TPSI) Fire Pits
INSTALLATION PRECAUTION:
PN#900490
DO NOT DISCARD. THIS MANUAL
HAS IMPORTANT OPERATING AND
MAINTENANCE INSTRUCTIONS.
LEAVE WITH THE HOMEOWNER.
MODEL:
SERIAL #:
Description
Advertisement
Table of Contents
Related Manuals for Firegear PRO FPB-34DPSTPSI-N-SAN
Summary of Contents for Firegear PRO FPB-34DPSTPSI-N-SAN
- Page 1 DO NOT DISCARD. THIS MANUAL HAS IMPORTANT OPERATING AND MAINTENANCE INSTRUCTIONS. LEAVE WITH THE HOMEOWNER. “PRO SERIES” MODEL: SERIAL #: MODELS Models - Natural Gas Models Propane Gas Description FPB-34DPSTPSI-N-SAN FPB-34DPSTPSI-P-SAN 34” Round Burner with 18” Snowflake Burner FPB-26DPSTPSI-N-SAN FPB-26DPSTPSI-P-SAN 26” Round Burner with 11” Snowflake Burner Round Flat Pan Thermocouple Piloted Safety Ignition (TPSI) Fire Pits Installation and Operating Instructions...
-
Page 2: Carbon Monoxide Hazard
CARBON MONOXIDE HAZARD DANGER This appliance can produce carbon monoxide which has no odor. Using it in an enclosed area can kill you. Never use this appliance in an enclosed space such as a camper, tent, car or home. DANGER WARNING FIRE OR EXPLOSION HAZARD... -
Page 3: Table Of Contents
Fire Pit Maintenance/Trouble Shooting Optional Accessories Congratulations! You have just purchased a Firegear Outdoors “Pro Series” Snowflake Burner. The Brass Burners are 11” and 18” diameter models. Each model incorporates individual injectors that eliminates the need for a main burner orifice. The 11” model incorporates 8 injectors the 18” incorporates 24 injectors. -
Page 4: Specifications
SPECIFICATIONS MODELS BURNER MINIMUM GROUND SIDE COMBUSTIBLE COMBUSTIBLE DIAMETER SIZE OPENING LEVEL WALL CEILING FLOOR N= Natural Gas P= Propane Gas FPB-26DPSTPSI-N-SAN 26” 11” 24” 8” 36” 96” 18” (660mm) (559mm) (610mm) (203mm) (914mm) (2438mm) (457mm) FPB-26DPSTPSI-P-SAN FPB-34DPSTPSI-N-SAN 34” 18” 32”... -
Page 5: Hard Piping To Fire Pit
Use the specifications listed on pages 4 and 5 for proper clearance to combustibles. Firegear Outdoors fire pits are constructed and tested to follow the rigid ANSI standards for gas appliances and manufactured safely providing dependable and certified products. If these fire pits are not installed according to the installation manual (i.e. -
Page 6: High Elevation
7. These products are designed for outdoor use only. Not approved for any indoor use. 8. This fire pit is designed to have Firegear Outdoors lava rock or glass media completely covering the burner tube, so that the burner is not visible. Do not cover more than 1” above the top of burner. Use lava rock a minimum of 1”... -
Page 7: Natural Gas : Pipe Sizing Chart
REFERENCE GAS PIPE SIZING CHART GAS PIPE SIZING NATURAL GAS : PIPE SIZING CHART Length of Pipe in Feet 1/2” 3/4” 1” 1 - 1/4” 1 - 1/2” 2” 2 - 2 1/2” 3” 4” • Natural Gas (NG) flow is given in 1237 2259 3640... -
Page 8: Removing Parts From Carton
REMOVING PARTS FROM CARTON Valve Assembly Flexible Gas Line Thermocouple Lead Piezo Wires Pilot Tubing Control Panel Hardware Carton Contents Fig. 5 Removing contents from carton. CONTROL PANEL MOUNTING PLATE This fire pit is comes partially assembled from the factory. The pilot tubing and thermocouple leads are 48”... -
Page 9: Pilot Assembly
REMOVING PARTS FROM CARTON Thermocouple PIEZO48WH Connection PIEZO25WH Pilot Gas Remove red button cap and install battery into Line Outlet Piezo ignitor module. To Burner Inlet Gas Plastic Nut Red Button Cap Supply Mounting Plate Fig. 8 Installing battery into Piezo. Piezo Ignition Control Knob Screen Hood... - Page 10 REMOVING PARTS FROM CARTON INJECTOR HOOD/RAIN SHIELD INSTALLATION Install the hood/rain shields over top of each injector of the pro brass burner by sliding it into position. Use the bead in the lower section of the hood, and align it with the groove in the injector, until it snaps into place.
- Page 11 Non-Combustible Enclosure Pilot Spur Burner Flat Pan Pilot Tube Piezo Wires Gas Valve Thermocouple Gas Supply Piezo Shut-O Gas valve and flexible gas lines are supplied; E-Stop shut- off is not supplied, but available in accessories page. Flex lines with flared fittings do not require Teflon tape or pipe compound.
-
Page 12: Operation
OPERATION CAUTION: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance. WARNING: Do not use this appliance if any part has been under water. - Page 13 TPSI REPLACEMENT PARTS Drawings Not to Scale Pro Series SF Burner - TPSI System Fire Pits REV. A Page 13...
-
Page 14: Replacement Parts
REPLACEMENT PARTS Qty. Item Description Part Number 34” Flat Round Disc/Pan PAN-SS34D 26” Flat Round Disc/Pan PAN-SS26D 11” Snowflake Burner- NG (used with FPB-26 @ 50K Btu’s) 10900 11” Snowflake Burner- LP (used with FPB-26 @ 42K Btu’s) 10901 18” Snowflake Burner- NG (used with FPB-34 @ 145K Btu’s) 10902 18”... -
Page 15: Fire Pit Maintenance/Trouble Shooting
FIRE PIT MAINTENANCE 1. The fire pit should be inspected and cleaned before initial use at least annually by a qualified field service person. 2. Any component that is found faulty must be replaced with an approved component. 3. Any tampering or modifying with the fire pit is dangerous and voids all warranties. 4. -
Page 16: Optional Accessories
OPTIONAL ACCESSORIES The following accessories are available from your local Firegear Outdoors dealer/distributor. Each accessory comes with a separate installation manual. Read each instruction thoroughly before installing. Paver Control Panels Media Glass Windshields PAVER-CP-TPSI TPSI systems See catalog for a windshield to fit your Lava Stones 1”... - Page 17 Pro Series SF Burner - TPSI System Fire Pits REV. A Page 17...
- Page 18 COMMERCIAL APPLICATIONS – MANUFACTURED AFTER 12/02/2019 BURNER SYSTEMS, BURNERS, COMPONENTS AND ACCESSORIES • TWO (2) YEAR WARRANTY ON CONSTRUCTION AND MANUFACTURER DEFECTS • TWO (2) YEAR WARRANTY - STAINLESS STEEL BURNERS AND PANS • TWO (2) YEAR WARRANTY - BRASS BURNERS •...
- Page 19 Product to be returned should; be packed so as not to incur damages during transportation. Firegear is not responsible for damages on returned items. RMA is valid for thirty (30) days from the date issued. The RMA must be clearly marked on the outside of the package.
- Page 20 We do not authorize any person or company to assume for it any other obligation or liability in connection with the sale, installation, use, removal, return, or replacement of its equipment, and or such representation are binding. Firegear Outdoors 17322 Gothard St.
- Page 21 Optional Cutout Template for TPSI Face Plate This fire pit instruction provides an option to mount the TPSI face plate to concrete board. Use the template above to complete the installation. The TPSI face plate can be mounted vertically or horizontally. Our suggestion is to attach the face plate in a horizontal position with the gas valve on the left side.
- Page 22 Having problems getting the gas appliance to operate? Don’t leave the job site! We want to help! Call 800.966.8126 for Technical Support between the hours of 8:00AM to 5:00PM PST. BEFORE YOU CALL WE WILL NEED THIS INFORMATION Model Number: ___________________________ Serial Number: ___________________________ How long is the gas line run? Nat Gas ____ LP Gas ____ What size is gas line? _____...
Need help?
Do you have a question about the PRO FPB-34DPSTPSI-N-SAN and is the answer not in the manual?
Questions and answers