AddSecure IRIS-4 Technical Reference Manual page 63

11 Technical specifications
Wi-Fi (if applicable)
Standard
Connection
Fault detection
Ethernet (if applicable)
Standard
Connection
IP addressing
Fault detection
Cellular (if applicable)
IRIS-4 models (from REV A25)
LTE (4G) Cat1
UMTS (3G)
GPRS (2G)
IRIS-4 240AP
LTE (4G) Cat1
UMTS (3G)
IRIS-4 models (up to REV A24)
LTE (4G) Cat4
UMTS (3G)
GPRS (2G)
Connection
Fault detection
IP
TCP ports (outbound)
Alarm transmission
Interface to Monitoring Center
Dial capture interface to alarm panel Two-wire interface via terminal block
Serial interface to alarm panel
PIN Inputs interface to alarm panel
Alarm protocols
Tamper detection reporting to
Monitoring Center
IEEE 802.11 b/g
2.4GHz b/g/n with internal PCB chip antenna
Loss of association/data
UTP 10/100 Base T with auto-negotiation
RJ45 socket for CAT5 cabling
Dynamic (DHCP) or fixed
Loss of Ethernet synchronization
B28A(700MHz), B20(800MHz), B8(900MHz)
B3(1800 MHz), B1(2100MHz), B7(2600MHz)
B8(900MHz), B3(1800MHz), B1(2100 MHz)
B8(900MHz), B3(1800MHz)
B28(700MHz), B5/B26/B18/B19(800MHz)
B8(900MHz), B3/B9(1800MHz), B1(2100MHz)
B5/B6/B19(800MHz), B8(900MHz), B1(2100MHz)
B20(800MHz), B8(900MHz), B3(1800 MHz)
B1(2100MHz), B7(2600MHz)
B8(900MHz), B1(2100 MHz)
B8(900MHz), B3(1800MHz)
SMA socket for antenna
Loss of registration with network
53165 (Alarms and Polling)
51292 (Diagnostic and Reflashing)
10001 (Upload/Download)
ISA or IRIS Management Suite via EN 50136-2 pass-through mode
RS485, TTL, RS232, RS232
Note: cabling must not exceed 3 meters
Maximum input voltage range 0V to +24V
Input 'low' (alarm) threshold < 1V
Input 'high' (restore) threshold > 2V
Internal pull-up impedance 10K to 3.3V supply
SIA (level 1 to 3) reference SIA DC-03-1990.01(R2003.10)
Contact ID reference SIA DC-05-1999.09
FF (Scancom)
Robofon (Dial capture only)
Telim (Dial capture only)
CESA (Dial capture only)
Dial capture interface
Serial Interfaces
Pin inputs
Lid & back tamper (cased units, apart from IRIS-4 50)
IRIS-4 Technical Reference Manual 20/03/2025
Note: Cabling must
not exceed 3 meters
page 63