AddSecure IRIS-4 Technical Reference Manual page 35

6.6 Wi-Fi: For terminal with Wi-Fi capability
If you selected Wi-Fi communication, this screen would now display.
This will display the name of the current Wi-Fi network and the current
password. Click on either to change them, then click «save»
Network
This will display the name of the current Wi-Fi network and allow you to change it.
Password
This will display the name of the current Wi-Fi password and let you change it.
Wi-Fi network scan
This option scans all available Wi-Fi networks and presents the results. If you
select one, you will be asked for that network password.
Wi-Fi signal strength
The terminal now checks the current Wi-Fi network strength and presents the
result.
IP address
Set "Auto" (DHCP) to view the allocated IP address, or "Fixed" to set a fixed
address, a subnet mask and a gateway. The MAC address is not changeable and
given as reference, to allow the configuration of MAC filtering by the premise's
network. When done, click «Back» to return to the Settings menu.
6.7 Cellular Settings: For terminals with cellular capability
This option lets you view and change the cellular
(2/3/4G) settings.
Signal strength
This option shows the provider and signal strength for the base station to which the terminal is connected.
Run network scan
This option performs a scan of all providers in the local area and presents a chart of the best three base
stations per provider.
This scan cannot be performed if the SIM card is fitted. Remove the SIM card by powering down the
terminal, removing the SIM card and then powering the terminal up.
The terminal scans for providers and base stations and reports the results with
signal strengths for eac. This can take a few minutes.
1
IRIS-4 Technical Reference Manual 20/03/2025
2
page 35