Printing A Demo Page; Changing The Display Language - Xerox Phaser 3600 User Manual

Item
Ethernet
Values: Auto, 10M Half, 10M Full, 100M Half,
Speed
100M Full
This item allows you to select the ethernet speed.
Clear This item performs a simple reset and restores the
Setting factory default settings for the network
configuration. This setting will only take effect after
you have reset the printer.
Network This item prints a page showing the network
Info. parameters you set.
802.1x
Values: Off, On
This item is for connecting with an authentication
server. If you need to connect this product to an
authentication server, set this item On, and select
one of the following authentication method. You can
select any method which the authentication server
supports among EAP-MD5, EAP-MSCHAPv2 and
PEAP.
Port 9100
Values: Off, On
This item lets you select whether or not you use port
9100.
• Off: You can disable the Port 9100 printing port.
• On: You can enable the Port 9100 printing port.
LPR
Values: Off, On
This item lets you select whether or not you use
LPR.
• Off: You can disable the LPR printing port.
• On: You can enable the LPR printing port.
IPP
Values: Off, On
This item lets you select whether or not you use the
IPP (Internet Printing Protocol) network connection.
• Off: You can disable the IPP.
• On: You can enable the IPP.
Explanation Item
SLP
Values: Off, On
This item lets you select whether or not you use the
SLP (Service Location Protocol) network
connection.
• Off: You can disable the SLP.
• On: You can enable the SLP.
CentreWare
Values: Off, On
IS
This item lets you select whether or not you use the
embeded web server called CentreWare IS. If you
turn this item Off, you cannot connect to the
printer's embeded web server.

Printing a demo page

Print a demo page to make sure that the printer is operating correctly.
1 Press Menu and then OK when Information appears.
2 Press the Up/down arrow buttons until Demo Page appears and
press OK.
A demo page prints out.

Changing the display language

To change the language that is displayed on the control panel, follow
these steps:
1 Press Menu until System Setup appears on the bottom line of the
display and press OK.
2 Press OK when Language appears.
3 Press the Up/down arrow buttons to select the language you want
and press OK.
4 Press Start/Stop to return to Standby mode.
2.9
<System setup>
Explanation