Printing A Demo Page; Changing The Display Language - Xerox Phaser 3428 User Manual

Item
Character
Values: ITALIC, PC437US, PC850
Tab.
This item selects the character set.
Pitch
Values: 10, 12, 17.14, 20
You can determine the font size by setting the number
of characters that will print in one horizontal inch of
type.
LPI
Values: 6, 8
You can set the number of lines printed in one vertical
inch.
Auto
Values: Off, On
Wrap
This item determines whether or not the printer
automatically performs line feed when the data
overflows the printable area of the print material.
Network menu (Phaser 3428/DN only)
This menu lets you configure the network interface installed in your
printer. You can reset the network interface and print a configuration
page.
Item
TCP/IP
Values: DHCP, BOOTP, Static
This item allows you to manually set the TCP/IP
addresses or receive the addresses from the
network.
• DHCP: The DHCP server allots the IP address to
you automatically.
• BOOTP: The BOOTP server allots the IP address
to you automatically.
• Static: You can enter IP address, subnet mask,
and gateway manually.
EtherTalk
Values: Off, On
This item lets you select whether or not you use the
EtherTalk protocol.
Explanation
Explanation
Item
NetWare
Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off
This item lets you select the IPX frame type.
• Auto: You can set the frame type automatically.
• 802.2: Select this value to use the IEEE 802.2
frame type.
• 802.3: Select this value to use the IEEE 802.3
frame type.
• Ethernet II: Select this value to use the Ethernet 2
frame type.
• SNAP: Select this value to use the SNAP frame
type.
• Off: You can disable the NetWare protocol.
Ethernet
Values: Auto, 10M Half, 10M Full,
Speed
100M Half, 100M Full
This item allows you to select the ethernet speed.
Clear This item performs a simple reset and restores the
Setting factory default settings for the network
configuration. This setting will only take effect after
you have reset the printer.
Network This item print a page showing the network
Info. parameters you set.

Printing a demo page

Print a demo page to make sure that the printer is operating correctly.
1 Press Menu and then OK when Information appears.
2 Press the Scroll buttons until Demo Page appears and press OK.
A demo page prints out.

Changing the display language

To change the language that is displayed on the control panel, follow
these steps:
1 Press Menu until System Setup appears on the bottom line of the
display and press OK.
2 Press OK when Language appears.
3 Press the Scroll buttons to select the language you want and press
OK.
4 Press Stop to return to Standby mode.
2.6
<System setup>
Explanation