Setting Up Fiery Webtools - Xerox DocuColor DocuColor 4 User Manual

5.1

Setting up Fiery WebTools

In order for network users to access and use the Fiery WebTools, you need to
set communication options in Network Protocol Setup on the control panel.
You also need to prepare each user's workstation to communicate with the
DocuColor 4 LP/CP over the Internet or intranet.
Instructions below apply to Windows 95/98, NT, and Mac OS computers us-
ing Ethernet protocols.
To set up Fiery WebTools on the DocuColor 4 LP/CP:
From the READY screen, press the Menu button on the printer's control
panel to access the printer/copier setup menus.
Press the Menu button until you see NETWORK PROTOCOL SETUP,
and press the Item/Enter button to access the TCP/IP screens.
In the next step you will enable TCP/IP network communication
according to your network type.
Use the right arrow button to advance to TCP/IP-ETHERNET screen.
Select YES to enable the appropriate communication protocol.
Use the arrow buttons to advance to the ETH. IP ADDRESS screen.
Enter a valid, unique IP Address for the DocuColor 4 LP/CP.
To set up Fiery WebTools on each client workstation:
Enable TCP/IP networking.
Make sure the workstation has a valid unique IP address.
Make sure the workstation is installed with an Internet browser.
In order for client workstations to access Fiery WebTools, they must use
a web browser. The recommended browser versions are:
for Mac OS computers, Netscape Navigator 3
for Windows computers, Netscape Communicator 4.0 or Microsoft
Internet Explorer 4.0.1
5
71