Subscribe to Our Youtube Channel
Related Manuals for Glow Bricks Lego Disney Tim Burton's The nightmare before christmas 21351
Summary of Contents for Glow Bricks Lego Disney Tim Burton's The nightmare before christmas 21351
- Page 2 Take lighting part A to assemble at the left side of the model...
- Page 3 Take out the pumpkins and the orange lighting round plates from the lighting part A, assemble them under the pumpkins Restore the pumpkins, assemble the led plate sticks on a 1x1 tile on the shown place right in front of the “RIP” gravestone...
- Page 4 The wire with connector attached would be moved to behind of the model by the corner Then assemble the remain lighting parts as shown...
- Page 5 Assemble the lighting part B to the middle part of the model Assemble them on two sides of the ladder...
- Page 6 Lift up the ladder then place the wire between the led plates in between the studs Then the lighting part B is installed...
- Page 7 Then take lighting part C for the right side of the model Start by removing the shown parts to install on the pool...
- Page 8 Assemble the lighting round plates on the pool evenly and it’s better to place the wires at the bottom Restore the pool, place the connector out to behind of the model and hide the wire by the wall...
- Page 9 Now take lighting part D to assemble on right side of the model Remove the roof, take out the top side and stick the led plate as shown...
- Page 10 Restore the blocks in the middle only and replace the flames by the lighting flames Put the roof back on and assemble the lighting plate as the ceiling light...
- Page 11 Take lighting part E to assemble at the middle part of the model Take the lighting round plates assemble them on the tree, the one connecting to the 1x2 lighting plate would be assembled right besides the wall...
- Page 12 After the lighting round plates are assembled, place the 1x2 lighting plate on middle of the house, then move the 1x4 lighting plate out to the front door and stable the wire by the tiles...
- Page 13 Restore upstairs then assemble the 1x4 lighting plate Stable the 1x2 lighting plates on the ceiling...
- Page 14 The remain lighting parts would be moved to the top of the house, remove the roof to let them get through Take one side of the roof, assemble the lighting plate as shown...
- Page 15 Then assemble the other side Close up the roof, move the lighting round plate to assemble it on the chimney...
- Page 16 Now you may combine the model and connect the plugs in between them Place the spot light right behind the moon, then you can connect all four connectors to the USB cable to light up the model...
Need help?
Do you have a question about the Lego Disney Tim Burton's The nightmare before christmas 21351 and is the answer not in the manual?
Questions and answers