Related Manuals for Glow Bricks Lego LandRover Classic Defender 90 10317
Summary of Contents for Glow Bricks Lego LandRover Classic Defender 90 10317
- Page 2 Start assembling the light for the front by the shown lighting parts...
- Page 3 Detach the bumper, front lights and the parts as shown Replace the tiles with studs on both of the front lights by the lighting parts, please assemble it exactly same position as the picture...
- Page 4 Before restoring the front lights, insert the connector into the shown spot, then the connector will be placed besides the tire...
- Page 5 Then restore the front lights back to the car And make sure the wire in between them are placed in between the studs in middle Now restore the parts in between the lights...
- Page 6 Put the clear parts back on the lights bulbs Replace the 1x2 black plates on the bumper by the remain lighting plates...
- Page 7 After all, restore the clear tiles on the bumper and put the bumper back, this part would be finished...
- Page 8 Now remove the shown parts of the car to assemble the lights for rear side Replace the clear red and orange round plates by the lighting parts, remember to follow the original colors...
- Page 9 Restore the LandRover tag to cover as many wires as you can, put the removed round tiles on the lights then move the rest lights in the car Assemble the lighting round plates on the left side Again put the round tiles back on the lights...
- Page 10 Assemble the 1x4 lighting plate as shown, detach the shown parts to make space for moving the black lighting plates to the top Place the wire in between the studs to prevent getting damaged when restoring the white parts removed from last step...
- Page 11 Put the removed parts back to the top Assemble the other 1x4 lighting plate as shown...
- Page 12 To the remain lights to the top, remove one of the slopes to make space for them and restore the slope after that Connect the wires with the other lighting parts...
- Page 13 The wire to the engine part can be placed in between the shown studs Then you can restore the windshield and the engine cover...
- Page 14 The only connect left inside the car will be used for powering up Now put the rack back on the car, assemble the lights and restore the clear round plates on them...
- Page 15 Place the rear lights on the rack and put the removed 1x2 clear tiles on them...
- Page 16 At last, you may choose to power up by USB or battery...
Need help?
Do you have a question about the Lego LandRover Classic Defender 90 10317 and is the answer not in the manual?
Questions and answers