CipherLab 9700 User Manual page 5

Before First Use
To use the CipherLab 9700 scanner first time, follow the steps:
1. Plug the USB cable into the dock and the PC.
2. Plug power into the dock and into an outlet.
3. Install the battery into the handheld.
4. Place the handheld on the dock.
NOTE! Please charge the CipherLab 9700 device for at least 8 hours before first use.
For more information, refer to the CipherLab's manufacturer documentation.
Rebooting Handheld
To reboot the handheld, follow the steps:
1. Take the handheld off of the dock.
2. Press and hold the red power button for a few seconds.
3. On the handheld device's screen, click Warm Boot.
4. Once it is completely booted up, place the handheld on the dock.
Training and Help
You can attend online Hand Held Training hosted every Wednesday at 1 PM EST. To join the training, follow
the steps as shown on Figure 2:
1. Log in C-Store Office using your account.
2. Open the training schedule of the Petrosoft Training Center. For that, do one of the following on the
C-Store Office home page:
Click the help button > Training Schedule.
o
At the right of the C-Store Office home page, find the Hand Held training in the section with
o
trainings information and then under the training name, click Join the training.
© Petrosoft LLC. All rights reserved. Confidentiality level – Internal use
CIPHERLAB 9700 WITH MOBILE ASSISTANT APPLICATION
/ Version 1.1
5