Bassinet Warnings; Bassinet Assembly, Fitting & Removal - Britax STRIDER PLUS Manual

BASSINET ASSEMBLY & OPERATION
28. BASSINET ASSEMBLY, FITTING & REMOVAL
WARNING: Remove Stroller seat or Infant Carrier from the frame before fitting Bassinet.
WARNING: Always remove your child from the Bassinet before fitting or removing from
the Stroller.
WARNING: Bassinet must always face towards the handle.
WARNING: The Bassinet must be removed from the frame before folding.
WARNING: Do not lift Stroller by the Bassinet. Only use Strider Bassinet with the Strider
Plus Stroller. Use a harness once the baby can sit up unaided.
A
To assemble bassinet,
locate straps in the centre
of the frame support rods
and pull straps slowly
outwards until each rod
slides and locks under all 4
clips.
D
Open canopy by
pressing and holding each
button on the outside of
canopy pivot joint before
rotating carry handle bar to
vertical position.
B
Frame support rods
are locked under all four
clips.
E
Fit the liner by aligning
the opening with the
main locking lever and
stretching it over both
corners of the Bassinet.
Ensure body band faces
upwards.
(OPTIONAL ACCESSORY)
C
Push down lightly
on the top edges of the
bassinet to check that the
frame supports are firmly
locked in place.
F
Fasten hook and loop
strip just under the main
locking lever.
29