enphase IQ Battery 10C Quick Install Manual page 7

NOTE: Perform installation and wiring, including
protection against lightning and resulting voltage surges,
in accordance with all applicable local electrical codes
and standards.
NOTE: Using unapproved attachments or accessories
could result in damage or injury.
NOTE: Install properly rated overcurrent protection as
part of the system installation.
NOTE: To ensure optimal reliability and to meet warranty
requirements, the IQ Battery(ies) must be installed
and/or stored according to the instructions in this guide.
NOTE: The Enphase IQ Battery 10C system requires an
internet connection through the IQ Gateway Metered
located inside IQ Combiner 6C. Failure to maintain
an internet connection may have an impact on the
warranty. See http:/ /www.enphase.com/warranty
terms.
NOTE: When replacing the Enphase IQ Battery(ies), you
must replace it with an IQ Battery(ies) of the same type
with the same AC current rating.
NOTE: When disconnected and stored, no automatic
charge of the battery is possible.
NOTE: Properly mount the IQ Battery(ies). Ensure that
the mounting location is structurally suited to bearing
the weight of the IQ Battery(ies).
NOTE: During use, storage, and transport, keep the
IQ Battery(ies):
• Properly ventilated.
• Away from the water, other liquids, heat, sparks, and
direct sunlight.
• Away from excessive dust, corrosive and explosive
gases like ammonia, and oil smoke.
• Away from direct exposure to gas exhaust, such as
from motor vehicles.
• Free of vibrations.
• Away from falling or moving objects, including motor
vehicles. If mounted in the path of a motor vehicle,
we recommend a 36 in (914 mm) minimum mounting
height.
• At an elevation of less than 9,842 feet (3,000 m)
above sea level.
• In a location compliant with fire safety regulations.
• In a location compliant with local building codes and
standards.
NOTE: Conditions for the IQ Battery 10C installation site
also apply to storage conditions.
NOTE: Enphase Energy System requires a utility grid
connection for commissioning and operation.
NOTE: Recycle packaging according to local guidelines.
Environmental Protection
ELECTRONIC DEVICE: DO NOT THROW AWAY.
Waste electrical products should not be disposed
of with household waste.
Proper disposal of batteries is required. Refer to
your local codes for disposal requirements.
for full
EN-7