Table of Contents
Advertisement
Replacing the lamps (Continued)
Resetting the lamp hours counter
After replacing the lamp(s), the lamp hour counter(s) should be reset to zero. Refer to
the following guide:
Press the [MENU] button on the control panel or remote to open the Main menu.
1
Press the p or q button to move to the [Reset] menu and press Enter.
The Reset menu is displayed.
Select [Clear lamp1 time] or [Clear lamp2 time] using p or q and press Enter.
A confirmation box is displayed.
Select [OK] using t or u and press Enter to reset the selected lamp
4
hours to zero.
68
Notes and Precautions
•
The Lamp1/2 time item in the Status display, Usage time screen indicates the time of
lamp use (use it as a rough estimate or guide for lamp life)
•
Please replace the lamp after 2000 hours of use with Lamp power set to Standard or
3000 hours of use with Lamp power set to Low
•
Attach the lamp cover correctly so that it is secure and not loose. If it is not attached
correctly, the projector may fail to turn on or the lamp may fail to come on.
•
There may be cases where the lamp stops working before the above mentioned period
expires or before the replacement message is displayed.
•
Always replace the lamp with a new one.
•
The lamp is made out of glass. Do not touch the glass surface with your bare hands,
bang it, or scratch it. (since dirt, jolts, scratches and other similar particles may affect
the lamp).
About the lamp replacement message
The projector's lamp replacement message displays after an appropriate period based on
the use period selected in [Lamp power].
When the replacement time approaches, the message of "The lamp1 and lamp2 has
reached the end of its usable life. Please replace the lamp." is displayed when power is
turned on and turned off. This display disappears when you press any key.
.
p.59
.
p.58
69
Advertisement
Table of Contents
