Displaying Information (Status Display); Maintenance; About Lamp - Toshiba TLP-XD2000 Owner's Manual

Using the menus (Continued)

■ Displaying Information (Status display)

This displays information about the input signal, lamp use time, etc.
Item
Projector
Input Input source name
Mode name RGB input mode
Resolution Resolution (in dots)
Frequency Sync frequency
Sync Sync signal polarity
Signal format Y/P /P
B R
Video mode Color method of video signal
Lamp time Time of lamp use
Lamp reset count The count for lamp replacement
Total time The total time that this projector
is used.
Version Firmware version
Notes
1: The mode of supported RGB signals
2: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
3: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as
a counter of guaranteed lamp time.) Please replace the lamp after 2000 hours of use if [Lamp
power] is set to [Standard], or after 3000 hours of use if [Lamp power] is set to [Low], consult
with a dealer about getting replacement for lamp TLPLW11 (sold separately).
4: [Version] shows the version of the projector's internal control program. This version is referred
to for customer service, etc.
Note
• The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
All manuals and user guides at all-guides.com
Description Computer Y/P
Yes
[Note 1] Yes
Yes
Yes
[Note 2] Yes
signal format No
No
[Note 3] Yes
Yes
Yes
[Note 4] Yes
p.51
is shown.
42
"Yes": displayed, "No": not displayed
/P Video S-video
B R
Yes Yes Yes
No No No
No No No
No No No
No No No
Yes No No
No Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes
Yes Yes Yes

Maintenance

About lamp

The product's light source is a mercury
to fully understand the following charac
• The lamp may burst with a loud n
the expiration of its life.
• How long it takes before the lamp
Some may burst shortly after first
• Burst is likely to happen if the lam
• When the lamp bursts, the broken
released outside from the opening
• When the lamp bursts, a slight am
glass dust may be released from
■ Immediately replace the la
• When the replacement time appro
• The risk of burst will increase if th
• Frequently check the used hours
approaches. (Refer to "Status disp
■ When the lamp is broken
• If glass components, including a l
pieces with care to avoid injury an
• In the event of lamp burst, unplug
ventilate the room. Then, thorough
any edible items placed in that are
• When the lamp bursts, consult a d
or you breathe it.