Table of Contents
Advertisement
Basic operations (Continued)
To alter the picture size,
press Menu and select the
[Adjust] menu using p or
q. Press Enter to open the
[Adjust] menu. Press t or
u to select [Display setting]
followed by p or q to select
[Screen]. Press Enter.
The [Screen] window is
4
displayed. Select the desired
picture size using p or q
and press Enter.
When finished, press
[Return] to go back to the
projected image.
Adjusting the volume
8
The volume can be adjusted with the
remote control unit.
Press the Vol +/- buttons
1
on the remote control. The
volume bar is displayed on
screen.
Use the Vol +/- buttons to adjust the level.
Notes
•
Volume can also be adjusted from the Volume in the Menu.
40
Notes
•
Note that lamp characteristics may rarely cause the brightness to fluctuate slightly.
•
A lamp is consumable item. If used for extended periods, images will appear dark, and the
lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of
the lamp depends on conditions of use.)
•
®
The DLP
chip is made using extremely advanced technology, but there may be black spots
(pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please
note that these are not malfunctions.
•
Although this projector supports a wide range of RGB signals
supported by this projector (WXGA) will be expanded or shrunk, which will affect image
quality slightly. To view high-quality images, it is recommended that the computer's
external output should be set to WXGA resolution.
•
With some models of computer having LCD displays or the like, displaying images
simultaneously on the projector and the monitor's display may prevent the images from
displaying properly. If this happens, turn off the computer's LCD display. For information on
how to turn off the LCD display, see the owner's manual of your computer.
•
If no signal is being input from the connected equipment or signal input is stopped while
projecting, the "No signal" will appear.
•
If a signal not supported by the projector is input, "No signal" message will appear.
•
If an unavailable operation button is pressed, "This function is not supported" will appear.
, any resolutions not
p.78
41
Advertisement
Table of Contents
