Table of Contents
Advertisement
Using the Status display screen (Continued)
The Network screen
Item p q
IP address
Displays the IP address associated with the projector, if connected to a network.
Subnet
Displays the subnet mask associated with the projector, if connected to a network.
Gateway
Displays the gateway associated with the projector, if connected to a network.
MAC address Displays the MAC address associated with the projector.
The Version screen
Item p q
Model name Displays the projector's model name.
Firmware
Displays the firmware version currently running on the projector.
Note
Firmware shows the version of the projector's internal control program. This firmware
version will be requested for customer service purposes.
Note
•
The displayed information will not be refreshed if the status changes. To refresh the
information, dismiss the display, then display it again.
Description
Description
60
Operation using an HTTP browser
Overview
The use of HTTP server functions will allow control of the projector from a web browser
without the installation of special software. Please be sure to use "Microsoft Internet
Explorer 4.x" or a higher version for the web browser. (This device uses "JavaScript" and
"Cookies" and the browser should be set to accept these functions. The setting method
will vary depending on the version of browser. Please refer to the help files and the other
information provided in your software).
HTTP server functions is available by accessing the following URL. Enter the either
address below in the browser address bar.
http:// <the projector's IP address> /index.html
http:// <the projector's IP address> /lanconf.html
Note
•
The display or button responses can be slow or operation may not be accepted
depending on your network settings. Should this happen, consult your network
administrator. The projector may not respond if its buttons are repeatedly pressed in
rapid intervals. Should this happen, wait a moment and repeat. If you still can't get any
response, turn off and back on the projector.
Preparation before use
Make network connections, set up the projector and confirm that it is complete before
engaging in browser operations.
Operation with a browser that uses a proxy server may not be possible depending on the
type of proxy server and the setting method. Although the type of proxy server will be a
factor, it is possible that items that have actually been set will not be displayed depending
on the effectiveness of the cache, and the contents set from the browser may not be
reflected in operation. It is recommended that you do not use a proxy server unless it is
inevitable.
Handling of the address for operation by using a
browser
Regarding the actual address that is entered for the address or entered to the URL address
bar when operation of the projector is via a browser, the host name can be used as it is
when the host name corresponding to the IP address of the projector has been registered
to the domain name server by a network administrator, or the host name corresponding
to the IP address of the projector has been set in the "HOSTS" file of the computer being
used.
Example 1:
When the IP address of the projector is 192.168.73.1, access is gained to the HTTP server functions
by specifying http://192.168.73.1/index.html for the address or the entry column of the URL
61
Advertisement
Table of Contents
