Table of Contents
Advertisement
Using the Setting menus (Continued)
The Setting 2 menu
Item p q
Projection
Set the projection mode. Press
• Standard—standard forward facing projection.
mode
• Rear ceiling—inverts and reverses the image for ceiling mounted projection from behind the screen.
• Rear—reverses the image for projection from behind the screen.
• Ceiling—inverts the image for standard ceiling mounted projection.
Display time Set the menu display time. Press
Continuous/5 sec./15 sec./45 sec.
Background Set the default background appearance. Press
Blue/None/Logo
Password
Enable or disable the password security feature
Key lock
Enable or disable the key lock security feature. When enabled, the control panel on the
projector is locked—the menus can only be accessed using the remote control.
Press
and select On or Off using p q.
DynamicBlack Enable or disable DynamicBlack. The DynamicBlack feature improves the appearance of black
areas of the projected image. Press
Enable or disable the front and reaer remote control sensors. Press
RC sensor
sensor mode using p q.
Both/Front/Rear.
Configure the network settings if the projector is connected to a network. Enable DHCP or
Network
disable DHCP and enter network IP address information in the supplied fields.
setting
Select Apply settings to confirm the network information
Select the desired standby mode. Press
Standby mode
Standard/Power-saving
Select the path for PC Control. Press
PC control
PC control/Network
Description
and select the projection mode using p q.
and select the display time using p q.
and select the background using p q.
p.45
.
and select On or Off using p q.
and select the
p.57
.
and select the standby mode using p q.
and select the PC control path using p q.
56
Network settings
<DHCP>
If you set DHCP to Enable, the IP address of the projector is assigned automatically
by the DHCP server. If your network environment does not assign IP addresses
automatically, set DHCP to Disable, then set the following items manually.
Note
•
IP address and Subnet are required fields if DHCP is set to Disable.
<IP address>
When DHCP is set to Disable, consult with your network administrator for the settings
below and set the IP address manually.
An IP address is a unique number assigned to a device. The format is a string of four dot-
separated three-digit numbers. (Example: 111.112.xxx.xxx)
<Subnet>
A subnet mask is used to determine what subnet the IP address assigned to a device belongs to.
(Example: 255.255.xxx.xxx)
<Gateway>
This value specifies the IP address of the device, such as a router, to be used to access servers
outside the network. (Example: 111.112.xxx.xxx)
<DNS>
This value specifies the IP address of a Domain Name Server (DNS) if present.
(Example: 111.112.xxx.xxx)
<Apply settings>
Select Apply settings to confirm the projector's new network settings.
57
Advertisement
Table of Contents
