Table of Contents
Advertisement
Using handy features
Using auto setting (computer input only)
This function automatically sets up the projector to the optimum state. It sets up the
sampling phase, frequency and screen position, etc., for each type of input signal
through a simple operation.
Press the AUTOSET button.
Notes
•
The image may not be projected or auto adjustment/setting may
not be performed correctly for input signals other than those
supported by the projector
.
p.78
•
If auto setting fails adjustment, adjust manually through Adjust,
Display setting menu
.
p.53
Correcting the keystone distortion
When the projector placement angle against the screen is changed while projecting
the image, the picture will undergo keystone (trapezoidal) distortion. This projector is
capable of correcting this keystone distortion.
Before correction
Adjusting Keystone distortion
Select the Setting menu using p or
1
q. Press Enter to open the Setting
menu. Press t or u to select Setting
1 followed by p or q to select
Keystone. Press Enter.
Use the t u buttons to adjust the keystone distortion.
2
Notes
•
Depending on the amount of keystone adjustment needed and the image content,
some information may be lost, or the picture quality may suffer.
•
The keystone correction settings are memorized after the power has been turned
off—the projector placement angle against the screen remains unchanged.
•
Some adjustments using keystone correction while displaying an input image with
a 16:9 aspect ratio, may affect displaying the menu properly. In such a case, reset
keystone correction to use the menu.
After correction
42
Cutting off the picture and sound temporarily (Mute)
When you want to project the images of another projector, overhead
projector, etc. temporarily, this projector's images and sound can be
turned off.
Remote
control
Press the remote control's MUTE button.
The picture and sound are cut off. (The Mute function is released
when pressing the MUTE button again.)
Notes
•
Operating any other functions will also cancel the muting.
•
The mute function is supported during most video and audio
playback.
Precaution
•
Do not replace the lens cap to cut off the projected image temporarily. It may cause
the lens cap to deform due to the heat.
Changing picture mode
The projected image mode can be selected.
Select the Adjust menu using p or q. Press Enter to open the Adjust
menu. Press t or u to select Image adjustment followed by p or q to
select Picture mode. Press Enter.
Press p or q to select the desired mode and press Enter.
Changing screen size
The screen size for the projected image can be changed.
Select the Adjust menu using p or q. Press Enter to open the Adjust
menu. Press t or u to select Display setting followed by p or q to select
Screen. Press Enter.
Press p or q to select the desired mode and press Enter.
Notes
•
Thru display is available for Computer and Network-input images.
•
Wide display is available for Y/P
•
Using this function on commercial video software, broadcast or cable-broadcasting
except for the purpose of your private viewing and listening may infringe the
copyright protected by the copyright laws.
/P
, Video and S-video-input images.
B
R
43
Remote
control
Advertisement
Table of Contents
