Table of Contents
Advertisement
Replacing the filters
When the lamps are replaced, the filters should also be replaced, not cleaned.
Refer to the following guide to replace the filters.
CAUTION
•
Do not drop the projector on your hand or fingers while lifting the projector to
replace the filters. Doing so could injure your hand or fingers.
Note
•
The side and the rear filters can be pulled out from
the slots located at the bottom as shown.
Gently slide the filter holders in the direction
1
shown.
Lift the filter foams from all three filter
holders in the direction shown.
Remove them completely from each filter
holder and discard.
Place a replacement foam and press down
firmly.
Replace the filter holders by pushing gently
4
in the direction shown.
Note
•
When dirt and dust build up in the filter, the air circulation inside the projector is
affected and the internal temperature will rise, causing the projector to stop working or
malfunction.
•
Be sure the filter is inserted all the way into the slot. Leaving gaps will allow dust and
dirt to get inside the projector again.
•
When you purchase a new lamp, new filters are also provided. If a filter is torn or dirty,
please replace with new one. Continuing to use a ripped filter will allow dust and dirt to
get inside the projector.
•
Never run the projector with the filters removed. It is recommended that you clean the
Bottom
Resetting the filter time counter
After replacing the filters, the filter time counter should be reset to zero. Refer to the
following guide:
Press the MENU button on the control panel or remote to open the Main menu.
1
Press the p or q button to move to the [Reset] menu and press Enter.
The [Reset] menu is displayed.
Select [Clear filter time] using p or q and press Enter.
A confirmation box is displayed.
Select OK using t or u and press Enter to reset the filter time to zero.
4
Advertisement
Table of Contents
