Powering Up The Projector And Adjusting The Image - Toshiba TDP590 Manual

S e t t i n g
NOTE: Always use the power
cord that shipped with the
projector.
NOTE: With some computers,
the order in which you power up
the equipment is very important.
Most computers should be
turned on last, after all other
peripherals have been turned
on. Refer to your computer's
documentation to determine the
correct order.
14
u p t h e

Powering up the Projector and Adjusting the Image

1 Remove the lens cap.
2 Plug the power cord into the side of the projector, then plug it into
your electrical outlet. A surge-protected power strip is recom-
mended.
3 Turn on the projector by pressing the "I" side of the power switch
(see Figure 2 on page 3).
The TOSHIBA startup screen displays and the Power LED on top
•
of the projector lights up (Figure 16 on page 20).
4 If you connected a video player, turn it on.
The video image should display on the projection screen. If a
•
computer source is active, press the
(page 20) or the
image. You can select a default source to determine which source
the projector examines first during power-up for active video; see
"Default Source" on page 29.
Use the
•
5 Turn on your computer.
The computer image should display on the projection screen. (If a
•
video source is active, press the
(page 20) or the
computer's image.)
If necessary, make adjustments to the image from the projector's
•
on-screen menus. To open the menus, press the
the keypad or remote, then select the Display or Image sub-menu.
For more information about the menus, see page 22.
P r o j e c
button on the remote to display your video
video
buttons to adjust the volume.
volume
button on the remote to display your
computer
t o r
button on the keypad
source
button on the keypad
source
menu
button on