Humanscale Float Gather Assembly Instructions Manual page 3

IMPORTANT SAFETY INSTRUCTIONS
• BEFORE MOVING THE TABLE, CLEAR OBJECTS FROM WORKSURFACE AND PLACE THE WORKSURFACE IN THE LOWEST POSITION.
• Use two hands on the side of the table when raising and lowering the worksurface.
• Do not raise or lower the table with open beverages on the worksurface.
• Avoid any fast or hard impacts on the sides of worksurface to avoid unintentional tipping.
• When in use ensure no blockage or obstruction is near to prevent tipping.
DO NOT:
• Put more than 125 lbs on the worksurface.
• Lean on the table worksurface.
• Mount unauthorized items to the worksurface or table (i.e., monitor arms, charging devices, power strips/cords, etc.).
• Move the table in the raised position.
• Replace the worksurface with another worksurface.
• Use the table on angled surfaces, platforms, coarse/textured/uneven floors, stairs or ramps.
• Place the product outdoor or expose it to outdoor elements (wind, excessive sunlight, continuous moisture).
• Sit or stand on the worksurface.
• Take apart the Column with Actuator.
• Tamper with internal mechanism.
• Apply excessive heat to any part of the product.
Assembly Instructions
*Some assembly steps may require 2 people for safety.
Attach user interface indicator to top of work surface
1
Secure the user interface indicator into the groove in top of the work surface with the
M3x0.5x16mm (2) screws using the 2mm hex key provided.
3